Maintenance & ServiceNovember 13, 2026· 3 min read

Hot Tub Won't Heat? Common Causes and What to Check First

The most common reasons a hot tub stops heating, the safe checks you can do yourself, and the signs it's time to call a service tech.

Draft for Eddy's review. Visible on the preview; set draft: false in the post's frontmatter once approved.
Hot tub not heating? The first five things to checkVideo coming soon

“My tub won’t heat” is one of the most common service calls there is. The good news is that a fair number of them turn out to be something simple. Here’s what I check, roughly in order.

Safety first. Hot tubs run on high-voltage power. Turn the power off at the breaker before you remove any equipment panel. Anything involving wiring, the heater element, or the control board is a job for a qualified technician.

1. Check the display for an error code

Most modern tubs show a code when something’s wrong (flow, sensor, overheat, freeze protection and so on). Write it down exactly as shown and look it up in your owner’s manual; codes differ by manufacturer and control system. That code is the single most useful thing you can give a tech.

2. Check the settings

It sounds obvious, but it happens a lot:

  • Is the set temperature actually higher than the current water temperature?
  • Is the tub in an economy, sleep or away mode that only heats during certain times?
  • Did a power blip reset the clock or the filter cycles?

3. Check power and the GFCI

  • Did the GFCI breaker trip? If it trips again right after you reset it, stop and call a technician. A GFCI that keeps tripping is protecting you from a real problem.
  • Is the tub getting power at all (lights, display, pumps)?

4. Check water flow

Heaters need good water flow to run safely, so a lot of “no heat” problems are really flow problems.

  • Dirty or clogged filters are the number one culprit. Pull the filters and try running the tub briefly without them (only as a test, per your manual). If it heats, clean or replace the filters.
  • Low water level can starve the pump. Top it off.
  • Closed valves after a drain and refill.
  • Airlock after refilling: air trapped in the pump stops it from moving water. Your manual will describe how to bleed it, often by loosening a union on the pump slightly until water comes through.

5. Check the cover and the weather

In cold weather, a tub with a worn, waterlogged, or poorly sealed cover can lose heat nearly as fast as it makes it. If the tub heats slowly but does heat, check the cover and the insulation before assuming a part has failed.

When it’s time to call a tech

Call for service if:

  • The GFCI trips repeatedly.
  • You get an error code that points to a sensor, heater, or high-limit problem and the basics above don’t clear it.
  • Flow is good, filters are clean, settings are right, and it still won’t heat.
  • You smell burning, see scorch marks, or see water near electrical components. Turn the power off and leave it off.

Common parts a tech will look at include the heater element, temperature and high-limit sensors, the pressure or flow switch, the circulation pump, and the control board. Those are diagnosed with a meter, not guessed at, so don’t start buying parts on a hunch.

What to tell the tech

Save time (and maybe a second trip) by having this ready:

  • Brand, model and approximate year
  • The exact error code, if any
  • What you’ve already checked
  • When it started, and whether anything changed (refill, storm, power outage, new filters)

Got a specific tub that won’t heat? Ask on the board with the brand, model and any error code.

#troubleshooting#heater#error-codes#service

Still stuck?

Ask about your exact brand and model on the question board.

Ask Eddy →